Hello, again. This one was simple but I tried to make it pop a litle and really fit into the DC U scale. I started with 2 fresh out the box figures. DC U Green Lantern and DC U Spectre. Acetoned the green off the Spectre's neck, sanded the upper shoulder a lil to retain the paint when posed. Dr. Midnight's forearms, Mantis right fist, Green Lantern left open hand for carrying the lantern, Mantis feet, I think Green Arrows boots but the buts are have a ridge at the top. Sanded down Hal Jordans head and sanded dow the inner top of the Spectre's hooded cloak. Sculpted the light green dot of energy projecting from his chest. Taped down his lower shoulder with blue masking tape and perimered his torso grey. Highlighted the center of his chest with a lil white airbrush then taped aroud the dot so I can airbrush the dot leaving the white highlight on the chest when finished. Added a lil light green and a dab of yellow to highlight the cloak, boots, cape and green energy on his chest. Taped off and highlighted this one many times to get the thinnest and most even layers of painted. As always I sand down the areas that don't have enough clearance to retain the paint whhen articulated. I still have to add a few touch ups like the white around his armpits and shoulders. The ultra thins layer of primer with Testors sealant is holding very well and not rubbing off when posed. Thanks for looking and I hope you like!